![]() Maybe, a small bug might be there that kept the software from initialising the powerpose templates and it requires something like VB's "Doevent" command inbetween. But when i right clicked on the "Show Installed Files" as per your recomondation, the problem was solved. Strange Melaniet, i have tried various ways in the last few days but was unable to find out any solution regarding this. (Edited to correct an error in what I posted) ![]() Is this in a sub-folder of the same location where your G8F figure is installed? If you right-click on the powerpose templates entry in DIM and click on "Show Installed Files" - where is it putting them? Click on one of the files that are then listed and it should open the location where they are.
0 Comments
Leave a Reply. |